600 Series Chipset Family Platform Controller Hub
Datasheet, Volume 1 of 2
ID | Date | Version | Classification |
---|---|---|---|
648364 | 05/10/2022 | Public |
Legal Disclaimer
Revision History
Introduction
PCH Controller Device IDs
Memory Mapping
System Management
High Precision Event Timer (HPET)
PCH Thermal Sensor
Power Delivery
Pin Straps
Electrical and Thermal Characteristics
Ballout Definition
8254 Timers
Audio Voice and Speech
Controller Link
Processor Sideband Signals
Digital Display Signals
Enhanced Serial Peripheral Interface (eSPI)
General Purpose Input and Output
Intel® Serial I/O Inter-Integrated Circuit (I2C) Controllers
Gigabit Ethernet Controller
Integrated Sensor Hub (ISH)
PCH and System Clocks
PCI Express* (PCIe*)
Power Management
Real Time Clock (RTC)
Serial ATA (SATA)
System Management Interface and SMLink
Host System Management Bus (SMBus) Controller
Serial Peripheral Interface (SPI)
Intel® Serial IO Generic SPI (GSPI) Controllers
Testability
Intel® Serial I/O Universal Asynchronous Receiver/Transmitter (UART) Controllers
Universal Serial Bus (USB)
Connectivity Integrated (CNVi)
GPIO Serial Expander
Direct Media Interface
Private Configuration Space Target Port ID
Miscellaneous Signals
Functional Description
Configurable GPIO Voltage
GPIO Buffer Impedance Compensation
Interrupt / IRQ via GPIO Requirement
Programmable Hardware Debouncer
Integrated Pull-ups and Pull-downs
SCI / SMI# and NMI
Timed GPIO
GPIO Blink (BK) and Serial Blink (SBK)
GPIO Ownership
Native Function and TERM Bit Setting
Functional Description
Interrupt Generation
PCI Express* Power Management
Dynamic Link Throttling
Port 8xh Decode
Separate Reference Clock with Independent SSC (SRIS)
Advanced Error Reporting
Single - Root I/O Virtualization (SR - IOV)
SERR# Generation
Hot - Plug
PCI Express* Lane Polarity Inversion
Precision Time Measurement (PTM)
Timer Accuracy
The timers are accurate over any 1 ms period to within 0.05% of the time specified in the timer resolution fields.
Within any 100 us period, the timer reports a time that is up to two ticks too early or too late. Each tick is less than or equal to 100 ns; thus, this represents an error of less than 0.2%.
The timer is monotonic. It does not return the same value on two consecutive reads (unless the counter has rolled over and reached the same value).
The main counter uses the PCH’s XTAL as its clock. The accuracy of the main counter is as accurate as the crystal that is used in the system. The PCH’s XTAL clock frequency is determined by the pin strap that is sampled on RSMRST#.