ATX12VO (12V Only) Desktop Power Supply
Design Guide
ID
613768
Date
01/03/2022
Public
A newer version of this document is available. Customers should click here to go to the newest version.
Legal
Introduction
Processor Configurations
PCI Express* Add-in Card Considerations
Electrical
Mechanical
Acoustics
Environmental
Electromagnetic Compatibility
Safety
Reliability
CFX12V Specific Guidelines 2.0
LFX12V Specific Guidelines 2.0
ATX12V Specific Guidelines 3.0
SFX12V Specific Guidelines 4.0
TFX12V Specific Guidelines 3.0
Flex ATX Specific Guidelines 2.0
DC Output (Required)
DC Voltage Regulation (Required)
DC Output Current (Required)
Remote Sensing (Optional)
Other Low Power System Requirements (Required)
Output Ripple Noise (Required)
Capacitive Load (Recommended)
Closed Loop Stability (Required)
Multiple 12V Rail Power Sequencing (Required)
Voltage Hold-Up Time (Required)
Over Voltage Protection (OVP) (Required)
Short Circuit Protection (SCP) (Required)
No-Load Situation (Required)
Over Current Protection (OCP) (Required)
Over Temperature Protection (OTP) (Required)
Output Bypass (Required)
Separate Current Limit for 12V2 (Optional)
Overall Power Supply Efficiency Levels
Power Supply Efficiency for Energy Regulations - ENERGY STAR* and CEC PC Computers with High Expandability Score (Recommended)
SFX12V Specific Guidelines 4.0
Lower Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
Top Fan Mount Package – Physical Dimensions (Required)
Fan Requirements (Required)
Reduced Depth Top Mount Fan – Physical Dimensions (Required)
Fan Requirements (Required)
Standard SFX Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
PS3 Form Factor – Physical Dimensions (Required)
Fan Requirements (Required)
Fan Requirements (Required)
The fan will draw air from the computer system cavity pressurizing the power supply enclosure. The power supply enclosure shall exhaust the air through a grill located on the rear panel. Refer to Moving the fan to the computer system cavity helps to limit the acoustic noise of the unit.
The fan will be 80 mm.
To prevent damage to the fan during shipment and handling, the power supply designer should consider recessing the fan mounting, as shown in Figure 14-5.