31:24

0x0

RO

Data (DTA)

Reserved.

23

0x0

RO

Bus Power / Clock Control Enable (BPCE)

Reserved per PCI Express specification

22

0x0

RO

B2/B3 Support (B23S)

Reserved per PCI Express specification.

21:16

0h

RO

Reserved

15

0x0

RO

PME Status (PMES)

Indicates a PME was received on the downstream link.

14:13

0x0

RO

Data Scale (DSC)

Reserved.

12:9

0x0

RO

Data Select (DSEL)

Reserved.

8

0x0

RW/P

PME Enable (PMEE)

Indicates PME is enabled. The root port takes no action on this bit, but it must be RW for legacy Windows operating systems to enable PME# on devices connected to this root port.

7:4

0h

RO

Reserved

3

0x1

RW/O

No Soft Reset (NSR)

When set to 1 this bit indicates that devices transitioning from D3hot to D0 because of Power State commands do not perform an internal reset. Configuration context is preserved. Upon transition from D3hot to D0 Initialized state, no additional operating system intervention is required to preserve Configuration Context beyond writing the Power State bits.
When clear, devices do perform an internal reset upon transitioning from D3hot to D0 via software control of the Power State bits. Configuration Context is lost when performing the soft reset. Upon transition from D3hot to D0 state, full reinitialization sequence is needed to return the device to D0 Initialized.
Regardless of this bit, devices that transition from D3hot to D0 by a system or bus segment reset will return to the device state D0
Uninitialized with only PME context preserved if PME is supported and enabled.

2

0h

RO

Reserved

1:0

0x0

RO

Power State (PS)

This field is used both to determine the current power state of the root port and to set a new power state. The values are:
00: D0 state
11: D3HOT state
When in the D3HOT state, the controller's configuration space is available, but the I/O and memory spaces are not. Type 1 configuration cycles are also not accepted. Interrupts are not required to be blocked as software will disable interrupts prior to placing the port into D3HOT.
If software attempts to write a '10' or '01' to these bits, the write will be ignored.