Intel® System Debugger User Guide
Gordon Peak Modular Reference Board (GP MRB)
Prerequisites
Hardware Rework to enable Trace using Intel(R) Direct Connect Interface (Intel(R) DCI): Remove R9255 from the GP MRB board.
Connect a DebugAdapter, shown in the pictures below, to the MRB-DebugAdapter port (green square).
Make sure the DebugAdapter has power (USB cable to e.g. the host computer):
Make sure to have the DebugAdapter switch in the correct position:
Setup
Make sure that you have an Intel(R) DCI USB 3.x Debug Class debug cable available. These cables can be identified based on their yellow or orange connectors.
Connect the host machine’s super speed USB port (USB3) with the target machine’s super speed USB (USB3) port, using an Intel(R) DCI USB 3.x Debug Class debug cable:
Make sure that the target system shows up in the Windows device manager:
Once you have fulfilled all requirements in this chapter, you can switch on the target.