Manual Configuration

To configure the target connection manually, follow the steps below:

1. In the first step of Target Connection Assistant wizard, choose Manually select target, select your target from the list, and click Next.

   If you need to decode recorded Processor Traces or to analyze pre-captured trace, select the target that has been used for the process.

   

2. Select the required connection method. To display all probes supported for this target (but not currently detected), uncheck the Hide disconnected probes box.

   For decoding recorded Processor Traces or pre-captured trace analysis, select Offline (without a Target).

   

   Click Next.

3. Review the final settings in the Connection Summary dialog.

4. If you want to try to establish the connection right now, check the Connect to target on finish box at the bottom-right.

5. Click Finish.