Start Trace Capture

When your target is successfully connected, Start Trace buttons are enabled and your workspace should look as follows:

Launch trace capture as follows:

1. Click on the start trace button in Trace Capture view or in Eclipse toolbar to begin capturing trace data from target.

   

   or

   

2. The following progress dialog appears:

   

3. In the Project Explorer view, the Trace Capture file will appear in the capture folder, while the decodedfile will appear in sessions folder.

   

4. The Message View will open which will show the decoded Trace Messages in a table.

   The link: Message Distribution View shows the distribution of different types of Trace Messages over time.