Core™ Processors

Datasheet, Volume 1 of 2

ID 655258
Date 12/22/2021

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

Intel® Memory Thermal Management

DRAM Thermal Aggregation

P-Unit firmware is responsible for aggregating DRAM temperature sources into a per-DIMM reading as well as an aggregated virtual 'max' sensor reading. At reset, MRC communicates to the MC the valid channels and ranks as well as DRAM type. At that time, Punit firmware sets up a valid channel and rank mask that is then used in the thermal aggregation algorithm to produce a single maximum temperature

DRAM Thermal Monitoring

  • DRAM thermal sensing Periodic DDR thermal reads from DDR
  • DRAM thermal calculation Punit reads of DDR thermal information direct from the memory controller (MR4 or MPR) Punit estimation of a virtual maximum DRAM temperature based on per-rank readings. Application of thermal filter to the virtual maximum temperature.

DRAM Refresh Rate Control

The MRC will natively interface with MR4 or MPR readings to adjust DRAM refresh rate as needed to maintain data integrity. This capability is enabled by default and occurs automatically. Direct override of this capability is available for debug purposes, but this cannot be adjusted during runtime.

DRAM Bandwidth Throttling (Change to DDR Bandwidth Throttling)

Control for bandwidth throttling is available through the memory controller. Software may program a percentage bandwidth target at the current operating frequency and that used to throttle read and write commands based on the maximum memory MPR/MR4 reading.