ATX12VO (12V Only) Desktop Power Supply
Design Guide
ID
613768
Date
11/01/2023
Public
A newer version of this document is available. Customers should click here to go to the newest version.
Legal
Introduction
Processor Configurations
PCI Express* Add-in Card Considerations
Electrical
Mechanical
Acoustics
Environmental
Electromagnetic Compatibility
Safety
Reliability
CFX12V Specific Guidelines 2.1
LFX12V Specific Guidelines 2.1
ATX12V Specific Guidelines 3.1
SFX12V Specific Guidelines 4.1
TFX12V Specific Guidelines 3.1
Flex ATX Specific Guidelines 2.1
DC Output – REQUIRED
DC Voltage Regulation – REQUIRED
DC Output Current – REQUIRED
Remote Sensing – RECOMMENDED
Other Low Power System Requirements – REQUIRED
Output Ripple Noise – REQUIRED
Capacitive Load – RECOMMENDED
Closed Loop Stability – REQUIRED
Multiple 12V Rail Power Sequencing – REQUIRED
Voltage Hold-Up Time – REQUIRED/RECOMMENDED
Over Voltage Protection (OVP) - REQUIRED
Short Circuit Protection (SCP) - REQUIRED
No-Load Situation - REQUIRED
Over Current Protection (OCP) - REQUIRED
Over Temperature Protection (OTP) - REQUIRED
Output Bypass - REQUIRED
Separate Current Limit for 12V2 - OPTIONAL
Overall Power Supply Efficiency Levels
Power Supply Efficiency for Energy Regulations – ENERGY STAR* and CEC (California Energy Commission) PC Computers with High Expandability Score – RECOMMENDED
SFX12V Specific Guidelines 4.1
Lower Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
Top Fan Mount Package – Physical Dimensions (Required)
Fan Requirements (Required)
Reduced Depth Top Mount Fan – Physical Dimensions (Required)
Fan Requirements (Required)
Standard SFX Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
PS3 Form Factor – Physical Dimensions (Required)
Fan Requirements (Required)
DC Voltage Regulation – REQUIRED
The DC output voltages are required to remain within the regulation ranges shown in the Table 4-2, when measured at the load end of the output connectors under all line, load, and environmental conditions specified in Chapter 7.
The lower voltage range for +12V is allowed to be -7% to allow for the power excursion requirements now described in Section 3.1. To compensate for these power excursions the nominal voltage could be changed to 12.1 or 12.2 Volts, depending on Power Supply design.
Table 4-2: DC Output Voltage Regulation
Output | Range | Min | Nominal | Max | Unit |
+12V1DC1 | +5% / -7% | +11.20 | +12.00 | +12.60 | V |
+12V2DC2 | +5% / -7% | +11.20 | +12.00 | +12.60 | V |
+12VSB | +5% / -7% | +11.20 | +12.00 | +12.60 | V |
- Voltage tolerance is required at all connectors.