Intel® Ethernet 800 Series

Linux Performance Tuning Guide

ID Date Version Classification
636781 11/10/2026 Public
Document Table of Contents

​CPU Package C-State Control

By disabling deep C-states (C6/C6p), you prevent CPUs from falling into deep sleep, eliminating the wake-up delays that lead to packet drops. The CPU can still use light idle states like C 0 or C1 , meaning cores stay low-power when idle but wake up instantly to handle incoming traffic.

Some methods to check and control C-state entry within your OS are:

  • ​​Use the cpupower command to check and disable CPU C6/C6p state:

Check:

cpupower monitor or cpupower idle-info

Disable only C6/C6p States:

cpupower idle-set -d3 cpupower idle-set -d4

OR

Disable All C-States:

cpupower idle-set -D0

Note: Our modern Intel Xeon platforms (including Xeon 6 and 4th/5th Gen Xeon Scalable Processors), C-state behavior heavily impacts packet latency.

  1. Disabling C6/C6p: It removes deep-sleep exit delays that cause packet drops during sudden traffic bursts, while still allowing light idle states (C1/C1E) to maintain thermal efficiency .
  2. Disable All C-states recommended for polling workloads(such as AF_​XDP). It prevents cores from entering any low-power state, keeping them permanently in C0 for zero wake-up latency at the cost f higher power consumption. When Hyper Threading is enabled or disabled, disabling idle states prevents cores from entering low-power states during idle periods and reduces the latency for the CPU to transition between idle and active states.
  3. To prevent cores from dropping into low-power states during traffic, reduce the active queue count using "ethtool -L <ethX> combined <num_queues>"

Requirement:

This requires a strict 1:1 mapping between each network queue and a dedicated CPU cores to ensure network traffic continuously keeps assigned cores active and avoids latency spikes from power-state transitions

Enable C6/C6p:

cpupower idle-set -e3 cpupower idle-set -e4

Enable All C-States:

cpupower idle-set -E
  • ​​Another method is to utilize the tuned tool (included with many Linux distributions) to set a performance profile. These profiles modify several OS settings that can affect performance across many applications. It has been found that the network-throughput profile provides improvement to most workloads.

Check:

tuned-adm active

Set:

tuned-adm profile network-throughput

Note:tuned service must be running for above commands. To check/restart tuned: systemctl status tuned systemctl restart tuned