ATX12VO (12V Only) Desktop Power Supply
Design Guide
ID
613768
Date
01/03/2022
Public
A newer version of this document is available. Customers should click here to go to the newest version.
Legal
Introduction
Processor Configurations
PCI Express* Add-in Card Considerations
Electrical
Mechanical
Acoustics
Environmental
Electromagnetic Compatibility
Safety
Reliability
CFX12V Specific Guidelines 2.0
LFX12V Specific Guidelines 2.0
ATX12V Specific Guidelines 3.0
SFX12V Specific Guidelines 4.0
TFX12V Specific Guidelines 3.0
Flex ATX Specific Guidelines 2.0
DC Output (Required)
DC Voltage Regulation (Required)
DC Output Current (Required)
Remote Sensing (Optional)
Other Low Power System Requirements (Required)
Output Ripple Noise (Required)
Capacitive Load (Recommended)
Closed Loop Stability (Required)
Multiple 12V Rail Power Sequencing (Required)
Voltage Hold-Up Time (Required)
Over Voltage Protection (OVP) (Required)
Short Circuit Protection (SCP) (Required)
No-Load Situation (Required)
Over Current Protection (OCP) (Required)
Over Temperature Protection (OTP) (Required)
Output Bypass (Required)
Separate Current Limit for 12V2 (Optional)
Overall Power Supply Efficiency Levels
Power Supply Efficiency for Energy Regulations - ENERGY STAR* and CEC PC Computers with High Expandability Score (Recommended)
SFX12V Specific Guidelines 4.0
Lower Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
Top Fan Mount Package – Physical Dimensions (Required)
Fan Requirements (Required)
Reduced Depth Top Mount Fan – Physical Dimensions (Required)
Fan Requirements (Required)
Standard SFX Profile Package – Physical Dimensions (Required)
Fan Requirements (Required)
PS3 Form Factor – Physical Dimensions (Required)
Fan Requirements (Required)
Over Voltage Protection (OVP) (Required)
The over voltage sense circuitry and reference shall reside in packages that are separate and distinct from the regulator control circuitry and reference. No single point fault shall be able to cause a sustained over voltage condition on any or all outputs. The supply shall provide latch-mode over voltage protection as defined in the below table.
Table 4-15: Over Voltage Protection
Output | Minimum (V) | Nominal (V) | Maximum (V) |
+12 VDC (or 12V1DC and 12V2DC) | 13.4 | 15.0 | 15.6 |
+12VSB1 | 13.4 | 15.0 | 15.6 |
- Over voltage protection is RECOMMENDED but not REQUIRED for this output. While over voltage protection is not required for this output, system damage may occur in the case of an over voltage event.