ATX Version 3.0 Multi Rail Desktop Platform Power Supply
Design Guide
ID
336521
Date
02/01/2023
Public
A newer version of this document is available. Customers should click here to go to the newest version.
Legal
Revision History
Introduction
Processor Configurations
PCI Express* Add-in Card Considerations
Electrical
Mechanical
Acoustics
Environmental
Electromagnetic Compatibility
Safety
Reliability
CFX12V Specific Guidelines 2.0
LFX12V Specific Guidelines 2.0
ATX12V Specific Guidelines 3.0
SFX12V Specific Guidelines 4.0
TFX12V Specific Guidelines 3.0
Flex ATX Specific Guidelines 2.0
DC Output – REQUIRED
DC Voltage Regulation – REQUIRED
DC Output Current – REQUIRED
Remote Sensing - RECOMMENDED
Other Low Power System Requirements
Output Ripple Noise - REQUIRED
Capacitive Load – RECOMMENDED
Closed Loop Stability - REQUIRED
+5V DC / +3.3V DC Power Sequencing - REQUIRED
Voltage Hold-Up Time - REQUIRED
12V2 DC Minimum Loading - REQUIRED
Over Voltage Protection (OVP) – REQUIRED
Short Circuit Protection (SCP) – REQUIRED
No-Load Situation – REQUIRED
Over Current Protection (OCP) – REQUIRED
Over Temperature Protection (OTP) – REQUIRED
Output Bypass – REQUIRED
Separate Current Limit for 12V2 - OPTIONAL
Overall Power Supply Efficiency Levels
Power Supply Efficiency for Energy Regulations - ENERGY STAR* and CEC (California Energy Commission) PC Computers with High Expandability Score - RECOMMENDED
SFX12V Specific Guidelines 4.0
Lower Profile Package - Physical Dimensions - REQUIRED
Fan Requirements - REQUIRED
Top Fan Mount Package - Physical Dimensions -REQUIRED
Fan Requirements - REQUIRED
Reduced Depth Top Mount Fan - Physical
Fan Requirements - REQUIRED
Standard SFX Profile Package – Physical Dimensions - REQUIRED
Fan Requirements - REQUIRED
PS3 Form Factor-Physical Dimensions - REQUIRED
Fan Requirements - REQUIRED
Power-On Time – REQUIRED
The power-on time is defined as the time from when PS_ON# is pulled low to when the +12 VDC, +5 VDC, and +3.3 VDC outputs are within the regulation ranges specified in Table 4-2. The power-on time shall be less than 500 ms (T1 < 500 ms).
+5VSB shall have a power-on time of two second maximum after application of valid AC voltages as shown in Figure 4-5. The 5VSB power on time is T0 as listed in Section Section 4.3.4.