Jasper Lake EDS Vol1

Datasheet

ID 633935
Date 01/01/2021
Public Content

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents
DSP

Reset

Each host controller has an independent reset associated with it. Control of these resets is accessed through the Reset Register.

Each host controller and DMA will be in reset state once powered ON and require SW (BIOS or driver) to write into specific reset register to bring the controller from reset state into operational mode.

Note:To avoid a potential I2C peripheral deadlock condition where the reset goes active in the middle of a transaction, the I2C controller must be idle before a reset can be initiated.